Gage Series

With an initial selection of the gage size and pattern completed, the next step is to select the gage series, thus determining the foil and backing combination, and any other features common to the series. This is accomplished by referring to the Test Profiles table which gives the recommended gage series for specific sets of test requirements.

Options (If Any)

If the gage series is to have a standard option applied, the option should be tentatively specified at this time, since the availability of the desired option on the selected gage pattern in that series requires verification during the following step.

Gage Series (continued)

After selecting the gage series (and option, if any), reference is made again to Standard Gage Series table, used in conjunction with Catalog 500, Micro-Measurements Precision Strain Gages , to record the gage designation of the desired gage size and pattern in the recommended series. If this combination is not listed as available in the catalog, a similar gage pattern in the same size group, or a slightly different size in an equivalent pattern, can usually be selected for meeting the installation and test requirements. In extreme cases, it may be necessary to select an alternate series and repeat this process. Quite frequently, and especially for routine strain measurement, more than one gage size and pattern combination will be suitable for the specified test conditions. In these cases, it is wise to select a gage from the Super Stock Listings to eliminate the likelihood of extended delivery time or a minimum order requirement.

Page 14 of 20